Schneider-Electric
LTMR27PBD

Range: TeSys

Product name: TeSys T

Device short name: LTMR

Product or component type: Motor controller

Device application: Equipment monitoring and control

Measurement current: 1.35…27 A

[Us] rated supply voltage: 24 V DC

Current consumption: 56...127 mA

Supply voltage limits: 20.4…26.24 V DC

Communication port protocol: Profibus DP

Bus type: Profibus DP polarised 2-wire RS485 interface, addressing 1...125, transmission rate 9.6 kbit/s...12 Mbit/s, SUB-D 9 with 2 shielded twisted pairs, type A; Profibus DP polarised 2-wire RS485 interface, addressing 1...125, transmission rate 9.6 kbit/s...12 Mbit/s, terminal block with 2 shielded twisted pairs, type A

[Ui] rated insulation voltage: 690 V conforming to EN/IEC 60947-1; 690 V conforming to CSA C22.2 No 14; 690 V conforming to UL 508

[Uimp] rated impulse withstand voltage: 6 kV current or voltage measurement circuit conforming to EN/IEC 60947-4-1; 0.8 kV communication circuit conforming to EN/IEC 60947-4-1; 0.8 kV supply, inputs and outputs conforming to EN/IEC 60947-4-1

Short-circuit withstand: 100 kA conforming to EN/IEC 60947-4-1

Associated fuse rating: 4 A gG for output; 0.5 A gG for control circuit

Protection type: Overload; Thermal protection; Power factor variation; Overload (long time); Phase failure; Load fluctuation; Phase unbalance; Locked rotor; Earth-leakage protection; Thermal overload protection; Reverse polarity protection

Network and machine diagnosis type: Starting current and time; Fault recording; Remaining operating time before overload tripping; Motor control command recording; Running hours counter/operating time; Trip context information; Trip history information; Phase fault and earth fault trip counters; Event recording; Waiting time after overload tripping

logic input number: 6

Input current: 7 mA

Current state 0 guaranteed: Logic input: < 5 V and <= 15 mA for 5 ms

Current state 1 guaranteed: Logic input: < 15 V and 2...15 mA for 15 ms

maximum operating frequency: 2 Hz

Load current: 5 A at 250 V AC for logic output; 5 A at 30 V DC for logic output

Permissible power: 480 VA (AC-15), Ie = 2 A, 500000 cycles (output); 30 W (DC-13), Ie = 1.25 A, 500000 cycles (output)

Maximum operating rate: 1800 cyc/h

Contacts type and composition: 1 NO + 1 NC fault signal; 3 NO

Metering type: Average current Iavg; Temperature; Imbalance current; Phase current I1, I2, I3 RMS; Earth-fault current

Measurement accuracy: 5...15 % earth fault current internal measurement; 1 % voltage (100...830 V); 3 % power factor; 5 % earth fault current external measurement; +/- 30 min/year internal clock; 0,02 temperature; 1 % current; 5 % active and reactive power

Overvoltage category: III

Connection pitch: 5.08 mm

Connections - terminals: Control circuit: connector 1 cable(s) 0.25…2.5 mm² (AWG 24...AWG 14) flexible with cable end; Control circuit: connector 1 cable(s) 0.2…2.5 mm² (AWG 24...AWG 14) flexible without cable end; Control circuit: connector 1 cable(s) 0.25…2.5 mm² (AWG 24...AWG 14) flexible without cable end; Control circuit: connector 1 cable(s) 0.2…2.5 mm² (AWG 24...AWG 14) solid without cable end; Control circuit: connector 2 cable(s) 0.2…1 mm² (AWG 24...AWG 14) flexible with cable end; Control circuit: connector 2 cable(s) 0.2…1.5 mm² (AWG 24...AWG 14) flexible without cable end; Control circuit: connector 2 cable(s) 0.5…1.5 mm² (AWG 24...AWG 14) flexible without cable end; Control circuit: connector 2 cable(s) 0.2…1 mm² (AWG 24...AWG 14) solid without cable end

Tightening torque: Control circuit: 0.5…0.6 N.m flat screwdriver 3 mm

Pollution degree: 3

Electromagnetic compatibility: Electrostatic discharge, 3, 8 kV air, 6 kV contact, conforming to EN/IEC 61000-4-2; Radiated RF fields, 3, 10 V/m, conforming to EN/IEC 61000-4-3; Fast transients immunity test (other circuits), level 3, 2 kV, conforming to EN/IEC 61000-4-4; Fast transients immunity test (on supply and relay outputs), level 4, 4 kV, conforming to EN/IEC 61000-4-4; Voltage dips and interruptions immunity test, 70 %, 500 ms, conforming to EN/IEC 61000-4-11; Conducted RF disturbances, 10 V, conforming to EN/IEC 61000-4-6; Temperature sensor: surges (serial mode), 0.5 kV, conforming to EN/IEC 61000-4-5; Temperature sensor: surges (common mode), 1 kV, conforming to EN/IEC 61000-4-5; Control circuit: surges (serial mode), 1 kV, conforming to EN/IEC 61000-4-5; Control circuit: surges (common mode), 1 kV, conforming to EN/IEC 61000-4-5; Communication: surges (common mode), 2 kV, conforming to EN/IEC 61000-4-5; Relay outputs and supply: surges (serial mode), 2 kV, conforming to EN/IEC 61000-4-5; Relay outputs and supply: surges (common mode), 4 kV, conforming to EN/IEC 61000-4-5

Width: 91 mm

Height: 61 mm

Depth: 122.5 mm

Net weight: 0.53 kg

web services: Web server

Compatibility code: LTMR

Standards: UL 508; IACS E10; EN 60947-4-1; IEC 60947-4-1; CSA C22.2 No 14

Product certifications: C-Tick; CCC; ABS; NOM; LROS (Lloyds register of shipping); EAC; RINA; ATEX; GL; KERI; DNV; UL; CSA; RMRoS; BV

Protective treatment: 12 x 24 hour cycles conforming to EN/IEC 60068-2-30; 48 h conforming to EN/IEC 60070-2-11; TH conforming to EN/IEC 60068

Fire resistance: 650 °C conforming to EN/IEC 60695-2-12; 960 °C conforming to UL 94

Ambient air temperature for operation: -20…60 °C

Ambient air temperature for storage: -40…80 °C

Operating altitude: <= 2000 m without derating

Mechanical robustness: Vibrations mounted on symmetrical rail: 1 Gn, 5...300 Hz conforming to EN/IEC 60068-2-6; Vibrations plate mounted: 4 Gn, 5...300 Hz conforming to EN/IEC 60068-2-6; Shocks half sine wave acceleration: 15 Gn for 11 ms conforming to EN/IEC 60068-2-27

IP degree of protection: IP20

Unit Type of Package 1: Db

Number of Units in Package 1: 1

Package 1 Height: 7.2 cm

Package 1 Width: 10.0 cm

Package 1 Length: 13.6 cm

Package 1 Weight: 514.0 g

Unit Type of Package 2: S02

Number of Units in Package 2: 10

Package 2 Height: 15.0 cm

Package 2 Width: 30.0 cm

Package 2 Length: 40.0 cm

Package 2 Weight: 5.485 kg

Sustainable offer status: Green Premium product

REACh Regulation: Reference contains Substances of Very High Concern above the threshold

EU RoHS Directive: Compliant

Mercury free: Yes

China RoHS Regulation: Product out of China RoHS scope. Substance declaration for your information

RoHS exemption information: Yes

Environmental Disclosure: ENVPEP060308EN_V2

Circularity Profile: ENVEOLI100411EN_V2

WEEE: The product must be disposed on European Union markets following specific waste collection and never end up in rubbish bins

PVC free: Yes

Halogen content performance: Halogen free plastic parts product